CAPTO™ FORCE-LIMITING TEST 13 MM (1/2 IN)

TEST METHOD

CAPTO is designed to provide force-limiting overload protection. To generate data on CAPTO’s force-limiting behavior across industry ropes, the device was installed on seven different rope types in 3:1 and 1:1 mechanical advantage systems and pulled with increasing force until force-limiting slip occurred.

Tests were performed in a controlled laboratory environment. Tests were conducted using a fresh rope sample from a single lot of new rope for each rope type. The device was tested twice in a 3:1 and twice in a 1:1 for each rope type. Results were averaged to produce the graph below.

Note: this technical data is provided as a reference. While the CAPTO is intended to force-limit in overload situations, unforeseen or untested scenarios, environmental conditions, or other factors could prevent it from slipping to dissipate energy. In these cases, the total applied loads should not exceed 2500 lbf (11kN) to prevent damage to CAPTO, rope, or other system components. CMC recommends the use of an Enforcer Load Cell or other load-sensing device in training scenarios to better understand these limits. Refer to the manual for more information on proper use.

KEY TAKEAWAYS

• 13 mm CAPTO tested on seven 12.5-13 mm ropes limited peak forces in a 3:1 between 6.93 kN (1,559 lbf) and 9.99 kN (2,245 lbf).
• 13 mm CAPTO tested on seven 12.5-13 mm ropes limited peak forces in a 1:1 between 4.64 kN (1,042 lbf) and 7.9 kN (1,775 lbf).
• In all test cases, CAPTO’s force-limiting values were higher in a 3:1 than a 1:1 mechanical advantage system.
• In all test cases, CAPTO limited peak force loads to values below 25% of the published MBS for the given rope type.
• Both the test device and test ropes remained in serviceable condition following the force-limiting event.
• These results are representative. Force-limiting behavior is variable and influenced by many factors.